FOX PUMP INSTRUCTION
Thread pump onto air valve (approximately 4 turns). When pump is properly installed
PSI will register on pump gauge. Stroke the pump a few cycles. The pressure should
increase slowly. If pressure increases rapidly check to make sure that pump is
properly fitted and tightened onto the Schraeder valve. If shock has no air pressure,
the gauge will not register. Pump to desired PSI setting. When unthreading pump
from air valve fitting, the sound of air loss is from the pump hose, NOT the
shock itself.
NOTE: If you re-attach the pump, the hose will re-fill with
air. The will result in a lower PSI registering of approximately 15 to 20 PSI
on the gauge. Average setting is 100-300 PSI. DO NOT EXCEED 300 PSI. Replace
shock valve cap before riding. Fox pump is an option, available from Kona.
OVERVIEW | FRAME DESIGN | KONA
DUAL SUSPENSION DESIGN FEATURES
FOX
PUMP INSTRUCTION | KONA CROSS COUNTRY HARDTAIL FEATURES
KONA
COMPONENTS |
